3.4S / 3.8S / Classic S-type

This is the new replacement Lucas flasher unit, to fit most British cars made during the 1960s and newer. It is a direct replacement for the Lucas FL5 unit supplied with MGBs, Triumph TR4, TR5, TR250; later classic Mini, Austin-Healey 3000, Sprite; Morris Minor, Austin, and practically everything else that came with three Lucas-style push-on terminals.These units used to come in green Lucas boxes.  These now come in generic boxes but they are the same units. We also have new flashers with...

These are excellent reproduction Lucas-style Windtone horns, as used on a great many British cars of the 1950s and 1960s, including MGA, Triumph TR2, TR3, Austin-Healey Bugeye, 100 and 3000, Jaguar Mark VII, VIII, IX, X, MKI and MK2, XK120, 140, 150, and many others. They are sold as a pair, high and low note, and together they give a commanding sound. They are good quality but do not carry Lucas markings. Contact us if you just want one; we will sell them that way as well.  We have other...

This is an excellent reproduction high-note Lucas-style Windtone horn, as used on a great many British cars of the 1950s and 1960s, including MGA, Triumph TR2, TR3, Austin-Healey Bugeye, 100 and 3000, Jaguar Mark VII, VIII, IX, X, MKI and MK2, XK120, 140, 150, and many others.  They are good quality but do not carry Lucas markings. Some cars came with only a low-note horn; many like to add the high-note horn for a more commanding sound. We also sell a pair of high and low note...

This is a secondhand pedalbox, complete with pedals and hydraulics, for a Jaguar Mark I, II, 3.4S or 3.8S saloon. It's just the thing for converting an automatic car to a manual transmission. This one is obviously used and a little rusty, but all the parts are present for rebuilding, or you can replace the hydraulics with new parts.We prefer to send secondhand cylinders out to be sleeved in brass or stainless, rebuild them with new rubbers, and then they are better than new.This set is for a...

This laminated wooden wrench fits over 52mm Jaguar knock off spinners for tightening and loosening and protects them from hammer marks.We also stock an alternative design: long steel knock off wrenches. For these or 42 mm plywood knock off wrenches to fit MG, Austin-Healey, Triumph, etc.; knock off hammers and knock off spinners, see Related Products below.

SMITHS ammeters in classic British cars were usually rated at 30 amps, fine for the original generator, but in case you have upgraded to an alternator, you'll need one that can handle the extra amperage.This one is made by Caerbont, the successor to the SMITHS company, on original factory tooling in the same shop that the old company occupied. It comes complete with mounting bracket and light.NOT FOR USE WITH ALTERNATORS OF GREATER THAN 60 AMPS!

This is an excellent used spare wheel hold-down clamp for a Jaguar E-type of small saloon, including Mark I, Mark 2, 3.4 or 3.8S, 420, or Daimler 2 1/2 or 250. It has been stripped, cleaned and painted black.

This is a new SRB316 starter solenoid, but no longer supplied by Lucas or in a Lucas box.  It is the correct starter solenoid for most six-cylinder Jaguars, including XK120, XK140, XK150, E-type, Mark I, Mark 2, Mark VII, Mark VIII, Mark IX, Mark IX, S-type, 420, 240, 340, Daimler 2 1/2, 250, SP250, as well as early MGB, Triumph TR2, TR3, TR4, big Healey, Land Rover, and many others.

This is a good reproduction of a kit which was made in the 1960s and 1970s to adjust, tune and synchronize SU carburetors. We have a set of these and use them often. Well, as often as we bother to tune the SU's, that is, which isn't as often as we should.....Includes a jet wrench, instruction booklet and enough special carb tools to balance two or three carburetors.

Jaguar XJ cars came equipped with a comprehensive too kit from the factory. This is a particularly complete and nice example. The tools and spare bulbs and fuses appear to be original and correct. We believe this kit came from a so-called "XJ40" Jaguar, which might have been either an XJ6 or an XJ12. It would be a cool addition to any old Jaguar, though. It contains both metric and fractional wrench sizes.

This is a new forged steel 3/8" 12-point drive socket set, made by the venerable King Dick Tool Company in England. Included are Whitworth sizes 1/8" through 1/2". We use these sockets regularly in our shop and have found them to be of excellent quality.Whitworth fasteners were used on virtually all English cars and motorcycles through the 1970's.

We sell brand new Lucas ignition switches as well as lock inserts with keys. These are fine and work well, but the keys are marked LUCAS and are a different shape and keyway from the original Wilmot Breeden Union lock cylinder and keys. We have a very limited supply of brand new old stock units, all with the FS keyway. They were probably made in the 1960s or early 1970s by Wilmot Breeden in England. These cylinders are very rare, especially in new, unused condition, and once they are gone, we...